Home Subscription Services

The Journal of Adhesive Dentistry
JAD Home Page
About the Editor
Editorial Board
Author Guidelines
Submission Form
Reprints / Articles
Quintessence Publishing: Journals: JAD


The Journal of Adhesive Dentistry

Edited by Prof. Dr. Roland Frankenberger, Prof. Bart Van Meerbeek

ISSN (print) 1461-5185 • ISSN (online) 1757-9988


Spring 1999
Volume 1 , Issue 1

Pages: 7-23
Share Abstract:

Hybridization Effectiveness of a Two-Step Versus a Three-Step Smear Layer Removing Adhesive System Examined Correlatively by TEM and AFM.

Van Meerbeek, Bart; Yoshida, Yasuhiro; Snauwaert, Johan; Hellemans, Louis; Lambrechts, Paul; Vanherle, Guido; Wakasa, Kunio; Pashley, David H

Purpose: The objectives of this study were (1) to compare the hybridization effectiveness of two adhesive systems that are applied in respectively three and two steps, and {2} to determine the best resin-dentin interface preparation technique for atomic force microscopy (AFM). Materials and Methods: The resin-dentin interface produced by the three-step OptiBond Dual-Cure (Kerr} and its simplified two-step successor OptiBond Solo (Kerr)was ultramorphologically examined using transmission electron microscopy (TEM) and AFM. Four different methods were used to prepare interface specimens for AFM: (1) polishing to a 0.1pm finish with a silicon oxide suspension, (2) polishing to a 0.05-pm finish with an aluminum oxide suspension, (3) argon-ion etching, and (4) sectioning with a diamond knife. Results: Both TEM and AFM demonstrated that some collapse of the exposed collagen fibril network, due to gentle postconditioning air-drying of the dentin surface, may not have been totally recovered through hybridization by the two-step adhesive formulation as opposed to the three-step precursor. From the four interface preparation methods, only diamond-knife sectioning revealed sufficient ultramorphologic detail and high resolution that can capitalize on the high resolution offered by AFM. Conclusion: First, the findings suggest that simplifying the application procedure of adhesives by combining the primer and adhesive resin into a single application step may reduce hybridization effectiveness. Future research should confirm this effect for other two- versus three-step adhesive systems. Second, diamond-knife sectioning should be used for future topographic imaging and physicomechanical testing of resin-dentin interfaces by AFM.

Full Text PDF File | Order Article


  © 2022 Quintessence Publishing Co Inc

Home | Subscription Services | Books | Journals | Multimedia | Events | Blog
Terms of Use | Privacy Policy | About Us | Contact Us | Advertising | Help | Sitemap | Catalog